Home » Blog » Radio » Radio Frequency Interference » RFI Spectrum Hunter Loop

RFI Spectrum Hunter Loop

rfi spectrum hunter

By combining TinySA with my direction finder, I may be able to create a lightweight RFI spectrum hunter loop. Just the ticket for tracking down noisy neighbors.

A few years ago, I built a passive tuned loop for tracking down sources of RFI in my neighborhood. My RFI loop, shown above, uses capacitors to tune signals from 1 to 20 MHz. It also contains an attenuator.

By hooking up the loop output into the external antenna connector on my old Grundig YB-400 receiver, I am able to direction find many noise sources. But holding the top-heavy loop in one hand, and trying to tune the receiver with my other hand was a challenge. At one point, I thought of using my older SDRplay RSP2 with a PC for my portable direction finding.

I tried this with an Asus clamshell and an Huawei dual-boot tablet. My approach worked, but was even more cumbersome. At one point, I thought of “borrowing” a shopping cart from Walmart to support my man-portable RFI station.

But now, it strikes me that my new TinySA might do the job as a very portable RFI spectrum hunter. Shown above is my TinySA spectrum analyzer sitting on RFI direction finding loop. I think it would be easy to 3D print a mounting bracket to attach the TinySA to the loop’s wooden handle, and will try that next.

Naturally, a tuned DF loop is narrow bandwidth device. It is moderate Q so provides a sampling signal bandwidth of maybe 100 kHz. This means that I would have to set the scanning range on the TinySA to match the loop’s tuned frequency. But that should be possible, even if one handed.

RFI Spectrum Hunter Loop Sensitivity

My biggest concern is whether or not the TinySA is sensitive enough for the job. According to the specifications, TinySA has a minimum discernable signal of between -90 to -100 dBm. This is equivalent to S4 to S6, or a reasonably strong signal. So, I suspect that my tuned loop Q might provide a usable output for worst case RFI, but I would have to be reasonably close to the source.

It’s worth a try.

By the way, the TinySA comes with a small whip antenna, shown above. This works pretty well at VHF and above, but is useless at HF and below.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.